Output expander sensor cover removal
Note: This is not a FRU.
1 Remove the top cover. See “Output expander top cover removal” on page 446.
2 Push the latches (A) to release, then remove the sensor cover.
Sensor (media bin full) with flag removal
1 Remove the top cover. See “Output expander top cover removal” on page 446.
2 Remove the sensor cover. See “Output expander sensor cover removal” on page 449.
3 Remove the two screws (A) securing the sensor brace.
4 Disconnect the cable (B), and remove the sensor (media bin full) with flag.
4063
Repair information
449
To Next Page
Loading...
