4 Slide the rear door away from the machine, and remove it.
Base printer- front removals
• “Duplex exit diverter removal” on page 286
• “Front door removal” on page 288
• “Inner guide deflector removal” on page 289
• “Laser printhead removal” on page 291
• “Left inner cover removal” on page 295
• “Media aligner roller removal” on page 297
• “Media turn guide removal” on page 299
• “Media vertical guide removal” on page 300
• “MPF feeder lift plate removal” on page 302
• “MPF pick roller removal” on page 305
• “MPF tray removal” on page 308
• “Right inner cover removal” on page 309
• “Sensor (input) removal” on page 310
• “Sensor (toner density) removal” on page 312
• “Transfer roller left arm with cable removal” on page 313
• “Transfer roller right arm removal” on page 314
• “Transfer roller removal” on page 317
Duplex exit diverter removal
1 Remove the left cover. See “Left cover removal” on page 277.
2 Remove the controller board access shield. See “Controller board access shield removal” on page 351.
4063
Repair information
286
To Next Page
Loading...
