6 Remove the output bin sensor cover. See “Output bin sensor cover removal” on page 326.
7 Remove the sensor (standard bin full) with actuator. See “Sensor (standard bin full) removal” on page 329.
8 Remove the standard bin cover. See “Standard bin cover removal” on page 330.
9 Remove the control panel. See “Control panel removal (2.4‑inch screen)” on page 375or “Control panel removal
(4.3‑inch screen, 7‑inch screen)” on page 381.
10 Disconnect the left recoil spring.
11 Remove the e-clip (A) securing the pin to the left control panel hinge.
12 Remove the pin (B).
13 Remove the controller board access shield. See “Controller board access shield removal” on page 351.
4063
Repair information
401
To Next Page
Loading...
