Error code Description Action
200.03 Media is late reaching the sensor (input)
within the specified time.
See “Sensor (input) never‑ or late‑arriving jam service check”
on page 56.
200.05 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = MPF tray)
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 57.
200.07 Media reached the sensor (input) but did not
clear it within the specified time.
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 57.
200.08 Media is late reaching the sensor (input)
within the specified time.
See “Sensor (input) never‑ or late‑arriving jam service check”
on page 56.
200.09 The proper main motor feedback to start
laser servo was not received.
See “Main drive motor control jam service check” on page
59.
200.10 Printhead motor was not locked when page
reached the sensor (input).
See “Printhead motor control jam service check” on page
59.
200.11 Printhead motor fell out of lock after the
page reached the sensor (input).
See “Printhead motor control jam service check” on page
59.
200.12 Printhead was not ready for the page when
the sensor (input) was reached.
See “Printhead motor control jam service check” on page
59.
200.13 The page at the sensor (input) is not the next
page to be imaged.
See “Sensor (input) miscellaneous jam 1 service check” on
page 60.
200.14 Proper main motor feedback to start laser
servo was not received.
See “Main drive motor control jam service check” on page
59.
200.15 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 1)
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 57.
200.16 Main drive motor stalled. See “Main drive motor control jam service check” on page
59.
200.17 Fuser motor stalled. See “Fuser drive motor control jam service check” on page
60.
200.19 Paper never reached the sensor (input), but
it was successfully picked from the source.
See “Sensor (input) miscellaneous jam 1 service check” on
page 60.
200.25 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 2)
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 57.
200.32 Detected sensor (control panel interlock)
bounce.
See “S
ensor (input) miscellaneous jam 2 service check” on
page 61.
200.33 Printhead was not ready for page when
sensor (input) was reached.
See “Printhead motor control jam service check” on page
59.
200.34 Short media detected. See “Sensor (input) miscellaneous jam 3 service check” on
page 61.
200.35 Media reached the sensor (input) but did not
clear it within the specified time. (Media
source = Tray 3)
See “Sensor (input) late-leaving or did-not-clear jam service
check” on page 57.
4063
Diagnostic information
53
To Next Page
Loading...
