1 Pull down the rear door.
2 Firmly grasp the jammed paper on each side, and then gently pull it out.
Note: Make sure all paper fragments are removed.
3 Close the rear door.
4 To clear the message and continue printing, select Next > > Clear the jam, press OK > .
200.xx paper jams
Error code Description Action
202.01 Media remains on the sensor (narrow media)
during the warm‑up sequence (MS71x)
See “Sensor (narrow media) static jam service check” on
page 67.
202.01 Media remains on the sensor (fuser exit)
during the warm‑up sequence
See “Sensor (fuser exit) static jam service check” on page 64.
4063
Diagnostic information
62
To Next Page
Loading...
