What to do if the LSIS DC Drives show a constant red light?
If the LSIS DC Drive shows a constant red light, it could be due to communication issues. Ensure the communication and power supply cables are separated. Also, verify the status of the connected nodes.
What to do if ERROR indicator and CPU indicator are flashing synchronously in 1 second intervals on my LSIS Inverter?
Check the connector pins on the communication module for bends or other defects. If the problem persists after taking the measures listed above, it may indicate that the hardware is malfunctioning.
What to do if ERROR and CPU indicators are both turned off on my LSIS SV-iS7 Inverter?
This could indicate that power is not being supplied to the communication module. Correctly install the communication module to the inverter. Also, check the connector pins on the communication module for bends or other defects.
What to do if the CPU indicator is flashing in 1 second intervals, and the ERROR indicator is flashing in 2 second intervals on my LSIS Inverter?
First, check the communication link where the LAN cable is connected and ensure that the LINK indicator is turned on. Next, check the LAN cable and ensure that it is properly connected to the link port. Also, check to ensure that the communication module’s device name and [COM-22] Telegram Mode parameter settings match the network configuration at the PLC. Finally, ensure that the IP address assigned to the communication module is not already used by other devices on the same network.
General| Enclosure Rating | IP20 |
|---|---|
| Output Frequency | 0 ~ 400Hz |
| Frequency Range | 0.1 ~ 400 Hz |
| Power Range | 0.4kW |
| Overload Capacity | 150% for 60 seconds |
| Braking Unit | Built-in |
| Control Method | V/F control, Sensorless Vector Control |
| Protection Functions | Overcurrent, Overvoltage, Undervoltage, Overheat, Short circuit |
| Communication | RS-485 |
| Cooling Method | Forced air cooling |
| Ambient Temperature | -10°C to +40°C |
| Storage Temperature | -20°C to +65°C |
| Humidity | 5% ~ 95% RH (non-condensing) |
| Altitude | Up to 1000m |
Highlights potential risks of death or serious injury from incorrect operation.
Highlights potential risks of injury or damage to property from incorrect operation.
Covers general procedures and checks required before installing the inverter.
Instructions and checklist for correctly wiring the inverter's main and control circuits.
Introduction to operating the inverter using the standard keypad interface.
Overview of fundamental functions and operations of the inverter.
Guide to identifying and resolving common inverter issues and performing checks.
Common troubleshooting steps for issues like Over Load, Under Load, and Over Current.
Information on the inverter's safety features and compliance with safety standards.
Explanation of the STO safety function and its wiring.
To Next Page
