363-206-305
Issue 3, June 2000 Page 3 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
5.
IMPORTANT
: Unless otherwise directed, if one director-level procedure sends you to
another director-level procedure, you should not return to the first director-level
procedure after you complete the second.
6. Sometimes you will be asked to verify that things have occurred. This may take the
form of a formal statement of the expected response. At other times, the instructions
will merely state
verify that ...
.
If the expected response is not observed and a specific trouble clearing reference is
not made, you should reference the trouble analysis procedures under the
Trouble
Clearing
tab to clear the trouble.
7. When performing tests or procedures using a CIT and system commands, you
should refer to the "Commands and Reports" section of this manual for a description
of the command, its parameters, and the output messages associated with the
command.
8. If a procedure refers to software releases, for example Release 2 or later, it refers to
all releases with a numerical value of 2 or higher.
9. If you need assistance in clearing a trouble after completing all the applicable
trouble-clearing procedures in this section, contact your local or regional
maintenance assistance group. The telephone number for the Lucent Technologies
Regional Technical Assistance Center (RTAC) is 1-800-225-RTAC.
Circuit packs being returned for repair should be sent to the following address:
Lucent Technologies
Returned Goods Dept.
Dept. JC0221210
1600 Osgood Street
North Andover, MA 01845
Telephone: (978) 960-5179
Facsimile: (978) 960-1705
Screen Display and Panel Stamping Fonts
The procedures in this manual use a monospace font to identify actual text on a screen or a
response displayed from the system. A
bold
font identifies panel stamping, such as alarm
names or circuit pack names. Also, the
bold
font is used throughout this manual for
emphasis.
To Next Page
Loading...