363-206-305 Operation and Maintenance:
IXL-001
Issue 3, June 2000 Page 7 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Numerical List of TOP Procedures
Table A – Numerical List of TOP Procedure (Note)
Acceptance Tab
IXL-001 Acceptance Task Index
NTP-002 Overview of Acceptance (Test) Procedures for DDM-2000
FiberReach Multiplexer (Equipped) — Wideband
NTP-003 Test (Accept) DDM-2000 FiberReach Multiplexer
Shelf (Looped Back) — Wideband
NTP-004 Test (Accept) End-to-End DDM-2000 System (Network) —
Wideband Shelf
System Turnup/Circuit Order Tab
IXL-001 Task Index — System Turnup/Circuit Order
NTP-002 Add New DDM-2000 FiberReach Node
to a Dual Homed OC-1/OC-3/OC-12 RIng Off
an OC-3/OC-12/OC-48/OC-192 Ring
NTP-003 Discontinue DDM-2000 FiberReach Node (Shelf)
From Path Switched Ring Network
NTP-004 Establish Initial End-to-End DS1 Service
(Group Equipped but Not in Service)
NTP-005 Discontinue End-to-End DS1 Service
NTP-006 Add New DS1 Service
NTP-007 Equip DDM-2000 FiberReach Wideband Shelf (Looped Back)
NTP-008 Establish OC-1 Single-Homed FiberReach Access via
DDM-2000 OC-3 or OC-12 Backbone Ring
NTP-009 Establish OC-1 Dual-Homed FiberReach Access via
DDM-2000 OC-3 or OC-12 Backbone Ring
NTP-010 Establish OC-1 Stand Alone FiberReach Access via
DDM-2000 OC-3 Host Shelf
NTP-011 Install DS1 Protection Bus Module (1X1 or 1X7) System
Out-of-Service
NTP-012 Change DS1 Protection Bus Module (1X1 or 1X7) Low-Speed
Slots Out-of-Service
NTP-013 Establish Initial End-to End T1 Service (Low-Speed Slot
Equipped but Not in Service)
NTP-014 Add New T1 Service
NTP-015 Discontinue End-to-End T1 Service
NTP-016 Establish DDM-2000 OC-3c (STS-3c) Service
To Next Page
Loading...