IXL-001
: Operation and Maintenance 363-206-305
Page 10 of 12 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Detailed Level Procedures (DLP) Tab
DLP-500 Enable or Disable System Security and/or Edit, Delete, or
Enter a User’s Login
DLP-501 Replace BBG8/BBG8B SYSCTL - In Service
DLP-502 Replace ECC1/ECC2 User Panel (USPNL) In Service
DLP-503 Install/Remove Lightguide Buildout
DLP-504 Install OLIU Circuit Packs
DLP-505 Connect Optical Loop
DLP-506 DDM-2000 FiberReach Receiver Sensitivity Test
DLP-507 Install T1EXT Circuit Packs
DLP-508 Install DS1/DS1PM Circuit Packs
DLP-509 Perform LED Test
DLP-510 Perform DS1 Transmission Test
DLP-511 Remove –48 V DC User Panel Fuse
DLP-512 Activate Optional System Features Using CIT
DLP-513 Set Circuit Pack Options
DLP-514 Perform Optical Fiber Connections and Verification
of Optical Facility
DLP-515 Perform End-to-End OC-1, OC-3, or OC-12 Optical Line Test
DLP-516 Check Local Office Alarms
DLP-517 Perform OC-3c (STS-3c) Transmission Test
DLP-518 Make VT1.5 (DS1) or STS1 (DS3) Cross-Connections
Using CIT Single OC-3 or OC-12 Ring Configuration
DLP-519 Test Protection Switching Function
DLP-520 Condition DS1/DS1PM Circuit Pack/Port for New DS1 Service
DLP-521 Connect CIT and Establish Session
DLP-522 Establish Remote Login
DLP-523 Replace Circuit Pack
DLP-524 Install User Panel and Check –48 V DC Office Battery
DLP-525 Install Software Generic Program Network Element Software
New Shelf Installation Only BBG8/BBG8B SYSCTL Installed
DLP-526 Make VT1.5 (DS1) or STS1 Cross-Connections
Using CIT Single/Dual Homing OC3/OC1 or
OC-12/OC-1 Ring Configuration
Table A – Numerical List of TOP Procedure (Note)
To Next Page
Loading...