363-206-305 Operation and Maintenance:
IXL-001
Issue 3, June 2000 Page 11 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Detailed Level Procedures (DLP) Tab (Contd)
DLP-527 Clean Optical Fibers, Connectors, and
Lightguide Buildouts (LBOs)
DLP-528 Make VT1.5 (DS1) Cross-Connections Using CIT
Stand-Alone OC3/OC1 Ring Configuration
DLP-529 Check 197A BATTERY LOAD TEST SET
DLP-530 Make Cross-Connections Using CIT Single Homing/Linear
Extensions or Dual Homing OC-48/OC-3/12 and
OC-192/OC-3/12 Ring Configuration
DLP-531 Retrieve Generic Software Version ID
DLP-532 Perform Test of RT Batteries Using 197A BATTERY LOAD
TEST SET
DLP-533 Introduction to the PC
DLP-534 Copy Diskettes and Make Backups
DLP-535 Make Cross-Connections Using CIT Single Homing/Linear
Extensions or Dual Homing OC-12/OC-3 Ring Configuration
DLP-536 Install New Software Generic Program
Network Element Software
Local Shelf Download - In-Service System
DLP-537 Install New Software Generic Program
Network Element Software
Remote Shelf Download - In-Service System
DLP-538 Condition T1EXT Circuit Pack/Port for New T1 Service
DLP-539 Install BBG8/BBG8B SYSCTL — New Shelf
DLP-540 Install HDSL Circuit Packs
DLP-541 Obtain Equipment, Check Software, Prepare and Connect PC
for Software Download
DLP-542 Rear Access to the Wall DT Cabinet
DLP-543 Out Of Service Upgrade From 26-Type to 28-Type
or 29-Type OLIU Circuit Packs
DLP-544 Provision STS-1 Path Trace
DLP-545 Perform DS3 Transmission Test
DLP-546 Install DS3 Circuit Packs
Note:
Table A is provided as a reference only, and should not be used alone in finding
instructions for performing tasks.
Table A – Numerical List of TOP Procedure (Note)
To Next Page
Loading...