363-206-305 Acceptance:
Issue 3, June 2000 Page 1 of 2
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
NTP-002
Overview of Acceptance (Test) Procedures for
DDM-2000 FiberReach Multiplexer
(Equipped) — Wideband
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
1.
DLP-524
!
WARNING:
Unterminated optical connectors may emit invisible laser
radiation. Eye damage may occur if beam is viewed directly
or with improper optical instruments. Avoid direct exposure
to the beam.
!
CAUTION:
DDM-2000 FiberReach circuit packs contain static sensitive
components which can be damaged by electrostatic
discharge. A static ground wrist strap must be worn when
handling the circuit packs. See electrostatic discharge
considerations in
Trouble Clearing: TAD-100
.
NOTE:
This procedure is an overview of acceptance procedures
that may be performed on the DDM-2000 FiberReach
Multiplexer. It assumes that the DDM-2000 FiberReach
shelf has been installed and equipped with circuit packs. It
also assumes that the shelf is being tested (accepted) by an
organization that
did
not
install it. This procedure is for
reference only. It contains a list of items that may be
performed in doing acceptance of a shelf and is not intended
to be done in sequence.
Verify that office battery has been applied to the shelf. (PWR ON
A and B LEDs lit on User Panel.)
To Next Page
Loading...