Lucent Technologies FiberReach DDM-2000 - Page 1080

NTP-002
: Acceptance 363-206-305
Page 2 of 2 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
DLP-513
2. Set (check) circuit pack option switch settings, if required.
3. Test (accept) DDM-2000 FiberReach Multiplexer shelf (looped
back) [
Acceptance: NTP-003
].
4. Test (accept) DDM-2000 FiberReach optical span
[
Acceptance: NTP-004
].
DLP-510
5. If required, perform DS1 transmission tests on each DS1/T1 port.
DLP-545
6. If required, perform DS3 transmission tests on each DS3 port.
7. Verify/set option settings using rtrv-ne/set-ne:
DLP-512
8. Verify/set option settings using rtrv-()/set-():