363-206-305 Acceptance:
Issue 3, June 2000 Page 1 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
NTP-003
Test (Accept) DDM-2000 FiberReach Multiplexer
Shelf (Looped-Back) — Wideband
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
1.
!
WARNING:
Unterminated optical connectors may emit invisible laser
radiation. Eye damage may occur if beam is viewed directly
or with improper optical instruments. Avoid direct exposure
to the beam.
!
CAUTION:
DDM-2000 FiberReach circuit packs contain static sensitive
components which can be damaged by electrostatic
discharge. A static ground wrist strap must be worn when
handling the circuit packs. See electrostatic discharge
considerations in
Trouble Clearing: TAD-100
.
NOTE:
This test is to be performed if the DDM-2000 FiberReach is
being tested or accepted by an organization that did not
install it.
NOTE:
It is assumed that the DDM-2000 FiberReach is installed,
powered, equipped, and free of alarms. If it was not left in
that condition, notify the organization that installed the
DDM-2000 FiberReach that they have not completed the
installation or use Trouble Clearing: IXL-001.
NOTE:
If the DDM-2000 FiberReach fails to respond in the indicated
manner, you should refer the trouble to the organization that
installed the DDM-2000 FiberReach or use Trouble
Clearing: IXL-001.
To Next Page
Loading...