Lucent Technologies FiberReach DDM-2000 - Page 1193

363-206-305 Circuit Order:
NTP-018
Issue 3, June 2000 Page 5 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
11.
NOTE:
If a port is in the
nmon(n)
state, the signal is not monitored or
alarmed. The port will not automatically go to the
in
service(i)
state when a signal is detected as it will in the
auto(a)
state. In the
nmon
state, the port must be returned
to the
auto
state, using the
set-state-t1:
command, to
turn on monitoring of signal failures and before any circuit
packs associated with that port can be removed from the
equipment list by the upd command.
Use the
set-state-t1:
command to set the port state of the
DS1 port(s) of the circuit being established.
12. Use PairGain Technologies procedures to access the faceplate
RS-232 interface and set HDSL link management features for
each port being provisioned.