363-206-305 Circuit Order:
NTP-019
Issue 3, June 2000 Page 3 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . .FOR DETAILS, GO TO
NOTE:
The following commands may be used to convert, delete,
enter, and retrieve cross-connections: dlt-crs-vt1,
dlt-crs-sts1, ent-crs-vt1, ent-crs-sts1,
rtrv-crs-vt1, and rtrv-crs-sts1. See the
"Commands and Reports" section of this manual for a
description of commands. See "Cross-Connection
Provisioning" in the "Administration and Provisioning"
section of this manual for more information on
cross-connections.
Use the dlt-crs-vt1: command to delete the terminating
(drop) node cross-connections for all HDSL service being
removed, if required.
7. Use the dlt-crs-vt1: command to delete the pass-through
cross-connections at each nonterminating node for all DS1/HDSL
service being removed, if required.
8. If both HDSL ports on the HDSL circuit pack are being
discontinued, you may remove the HDSL circuit pack, if required.
9. If
all
HDSL circuit packs in the Low Speed Group are removed,
you may remove the protection HDSL circuit pack, if required.
10.
!
CAUTION:
No service DS1
Low Speed
slots should be left empty in
groups equipped with protection
HDSL
circuit packs.
NOTE:
177A Retainer Cards are used to disconnect the
cross-connect wiring associated with unused service DS1
slot locations from the DDM-2000's internal protection bus.
Install 177A Retainer Card(s), as required, into the DS1 slot(s) for
the HDSL circuit pack(s) removed.
To Next Page
Loading...