NTP-019
: Circuit Order 363-206-305
Page 4 of 4 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
11.
NOTE:
If a port is in the
nmon(n)
state, the signal is not monitored or
alarmed. The port will not automatically go to the
in
service(i)
state when a signal is detected as it will in the
auto(a)
state. In the
nmon
state, the port must be returned to
the
auto
state, using the
set-state-t1:
command, to turn
on monitoring of signal failures and before any circuit packs
associated with that port can be removed from the
equipment list by the upd command.
If circuit packs have been removed, momentarily depress the
UPD/INIT
button on the
SYSCTL
or use the upd command to
update the DDM-2000 internal equipment list.
If circuit packs have
not
been removed, use the
set-state-t1:
command to set the port state of the DS1 port(s) to
auto
or
nmon
,
as required.
12. Verify all alarms are off.
To Next Page
Loading...