NTP-023
: System Turnup 363-206-305
Page 2 of 20 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
NOTE:
It is assumed that all DDM-2000 OC-12 shelves in the
system have passed the looped transmission test(s)
(363-206-295,
DDM-2000 OC-12 Multiplexer,TARP Release
7, User/Service Manual (TOP) - Volume II
,
System Turnup:
NTP-002
or 363-206-285,
DDM-2000 OC-3
Multiplexer,TARP Release 13 and Later, User/Service
Manual (TOP) - Volume II
,
System Turnup: NTP-016
) and
the DDM-2000 OC-12 ring has been established (363-
206-295,
DDM-2000 OC-12 Multiplexer, TARP Release 7,
User/Service Manual (TOP) - Volume II
,
System Turnup:
NTP-020
or 363-206-285,
DDM-2000 OC-3
Multiplexer,TARP Release 13 and Later, User/Service
Manual (TOP) - Volume II
,
System Turnup: NTP-022
). It is
also assumed the DDM-2000 FiberReach shelves have
been equipped and tested,
System Turnup: NTP-007
.
Determine the network configuration (for example, see Figures 1,
2, 5, and 6.)
DLP-531
2. Verify that the DDM-2000 OC-12 host shelf is equipped with TARP
Release 7 or 13/15 ring software. If not equipped with TARP
Release 7 or 13/15 software, upgrade the DDM-2000 OC-12 host
shelf with proper software. Verify that the DDM-2000 FiberReach
hosted shelf is equipped with TARP Release 3 or 4 ring software.
3. Determine the optical loss of each optical span from office records
or by making the required measurements.
4.
NOTE:
The rtrv-eqpt: command retrieves the Equipage and
Version Report. This report lists the circuit pack type and
version information for one or more slots. See the
"Commands and Reports" section of this manual for a
description of the rtrv-eqpt: command format.
To Next Page
Loading...