363-206-305 Circuit Order:
NTP-024
Issue 3, June 2000 Page 5 of 12
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED . . . . FOR DETAILS, GO TO
6.
NOTE:
If Kbyte or Sbyte (sync messaging) is enabled for the
OC-3/OC-12 MAIN-1 and MAIN-2 optical interfaces at any
node in the OC-3/OC-12 ring, it must be enabled at all
nodes in the OC-3/OC-12 ring.
NOTE:
The rtrv-oc3: or rtrv-oc12:command retrieves the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report. This report displays the
provisioned configuration of OC-3/OC-12 lines. See the
"Commands and Reports" section of this manual for a
description of the rtrv-oc3: or rtrv-oc12: command
format.
Use the rtrv-oc3: or rtrv-oc12: command to obtain the
OC-3 Line Provisioning Report or OC-12 Line
Provisioning Report and verify if Kbyte/Sbyte is enabled.
Use the set-oc3: or set-oc12: command to enable the
Kbyte/Sbyte parameter, if required.
7.
NOTE:
If Sync Autoreconfiguration is enabled, Kbyte/Sbyte must
also be enabled.
NOTE:
If Sync Autoreconfiguration is enabled at any line-timed node
in a ring, it must be enabled at all line-timed nodes of a ring.
NOTE:
The rtrv-sync: command retrieves the
Synchronization Report. This report displays the
provisioning and operational information on the
synchronization attributes of the DDM-2000. See the
"Commands and Reports" section of this manual for a
description of the rtrv-sync: command format.
Use the rtrv-sync: command to obtain the
Synchronization Report and verify if Sync
Autoreconfiguration is enabled. Use the set-sync: command to
enable the Sync Autoreconfiguration parameter, if required.
To Next Page
Loading...