Lucent Technologies FiberReach DDM-2000 - Page 1314

NTP-032
: System Turnup 363-206-305
Page 6 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DO ITEMS BELOW IN ORDER LISTED. . . . .FOR DETAILS, GO TO
14.
NOTE:
The section data communication channel (DCC), used for far
end communications, must be enabled at each network
element (shelf) optical interface being tested in order for the
end-to-end line tests to work. Default condition for the DCC
channel is "enabled". If it has been disabled, use the
set-fecom: command
at each shelf
to enable far end
communications.
At each DDM-2000 FiberReach shelf, use the
set-fecom: address :com=enabled command to ensure far
end DCC communications (fecom) is enabled.
At each FT-2000 shelf, use the SECURITY-Set-Far End
Communications: command to ensure far end DCC
communications (fecom) is enabled.
DLP-514
15. Perform optical fiber connections and verification of the integrity of
the optical span being established.
16.
NOTE:
DDM-2000 shelves that are part of a subnetwork being
partitioned into multiple areas require that the NSAP AREA
field and level 2 IS-IS routing parameters of the
ent-ulsdcc-l3: command be set. See Section 11,
Commands and Reports in Volume I of this manual for an
explanation of the command parameters. FT-2000 shelves
that are part of a subnetwork being partitioned into multiple
areas require that the L3 Area Address and Level 2 IS
parameters of the CONFIGURATION-Set-ULSDCC-L3
command be set. See 365-575-103, FT-2000 OC-48
Lightwave System, Release 8.1 Through 9.1, User/Service
Manual , for an explanation of the command parameters.
See 824-102-144, Lucent Technologies 2000 Product
Family, Operations Interworking Guide For TARP Releases ,
for an explanation of the engineering rules for subnetwork
partitioning.