363-206-305 Trouble Clearing:
TAP-103
Issue 3, June 2000 Page 3 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
13. Was any trouble found?
If YES, continue with Step 14.
If NO, do TAP-108.
14. Determine reason for locks, inhibits, etc. to be in place. See the "Commands
and Reports" section of this manual for a description of the switch-( )
commands and the rtrv-alm command report descriptions. Use the
switch-( ) commands to reset switching mode or priority.
If you need assistance, notify your supervisor, your local technical support
organization, or call Lucent Technologies RTAC, per local operating
instructions.
15. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...