TAP-115
: Trouble Clearing 363-206-305
Page 2 of 2 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
8. Did the LED test fail again?
If
YES
, continue with
Step 9
.
If
NO
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE
.
9.
NOTE:
The problem appears to be in the backplane wiring of the FiberReach.
One way to verify this is to swap the
SYSCTL
and any circuit pack with an
inconsistent diagnostic indication with the corresponding circuit packs in
another FiberReach. If the problem moves with the circuit packs, it
means that one or more of the circuit packs is defective. If the problem
stays with the original FiberReach the entire assembly, but not the circuit
packs, should be replaced. The FiberReach has a printed backplane and
cannot be repaired in the field.
If you need technical assistance, notify your supervisor, your local technical
support organization, or call Lucent Technologies RTAC, per local operating
instructions.
10.
STOP. YOU HAVE COMPLETED THIS PROCEDURE
.
To Next Page
Loading...