363-206-305 Detailed Level Procedure:
DLP-500
Issue 3, June 2000 Page 1 of 8
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Enable or Disable System Security and/or Edit
Delete, or Enter a User’s Login
1.
!
CAUTION:
You must wear an ESD wrist strap plugged into one of the grounding
jacks (located on both sides of the assembly) whenever working with the
DDM-2000 FiberReach.
Connect CIT to the desired shelf and establish session.
Reference: DLP-521
2. Are you going to enable or disable system security or are you going to edit,
delete, or enter a user's login?
If Enable or Disable System Security, continue with Step 3.
If Edit, Delete, or Enter a User's Login, proceed to Step 15.
3.
NOTE:
You must be logged into the system as one of the three privileged users
to enable or disable system security. Initially, the defaults for the
privileged user logins (Release 2.1 and later) are LUC01 (upper case
LUC-zero-one), LUC02 (upper case LUC-zero-two), and LUC03 (upper
case LUC-zero-three); however, these defaults may have been changed.
For Release 2.0 and earlier, the defaults for the privileged user logins are
ATT01 (upper case ATT-zero-one), ATT02 (upper case ATT-zero-two),
and ATT03 (upper case ATT-zero-three). The CIT login banner for
Release 2.0 and earlier reads: AT&T, DDM-2000 FiberReach,
Release a.b.c.
NOTE:
System security requires the defaults for the privileged user
logins/password to be changed and CIT and/or DCC port security to be
enabled.
At the login< prompt, enter a valid privileged user login (provided by your
DDM-2000 administrator).
Response: password<
To Next Page
Loading...