Lucent Technologies FiberReach DDM-2000 - Page 1488

DLP-500
: Detailed Level Procedure 363-206-305
Page 2 of 8 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
4.
NOTE:
Check with the DDM-2000 administrator to determine what the default
privileged password is set to.
NOTE:
Passwords are not displayed on the CIT.
At the password< prompt, enter a valid privileged user password (provided
by your DDM-2000 administrator).
Response: CIT prints the following message followed by an Alarm
and Status Report:
5.
NOTE:
After the prompt ( < ), the system will respond to commands entered.
The set-link:pg=( ) command may be used to set the vertical size
of the displayed page on the CIT. Page (pg) length may be set from 3 to
150 lines with a default length of 24 lines.
TID date time
M rtrv-alm: all COMPLD
/* Active Alarms and Status Report
Lucent Technologies
DDM-2000 FiberReach
Release a.b.c
**********************************
**********************************/
/
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
.
.
.