363-206-305 Detailed Level Procedure:
DLP-500
Issue 3, June 2000 Page 3 of 8
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Did you use the default privileged user login (LUC01, LUC02, or LUC03) and
password to log into the system?
If YES, continue with Step 6.
If NO, proceed to Step 8.
6.
NOTE:
The defaults for privileged user logins (LUC01, LUC02, and LUC03) and
password must be changed for system security. There are always three
privileged user logins. (Privileged user logins cannot be added or
deleted.) See the "Commands and Reports" section of this manual for a
description of the set-lgn: command format.
Use the set-lgn: command to change the defaults for the privileged user
logins (LUC01, LUC02, and LUC03) and password.
7.
NOTE:
The rtrv-lgn: command retrieves the Login Provisioning
Report. This report lists each user's login and authorization level (user
type). The report does not contain passwords. See the "Commands and
Reports" section of this manual for a description of the rtrv-lgn:
command format.
Use the rtrv-lgn: command to obtain the Login Provisioning
Report and verify that the privileged user logins have been changed.
8.
NOTE:
The rtrv-secu: command retrieves the Port Security
Configuration Report. This report provides CIT and DCC port
security and timeout information. See the "Commands and Reports"
section of this manual for a description of the rtrv-secu: command
format.
Use the rtrv-secu: command to obtain the Port Security
Configuration Report and note the CIT/DCC port security and timeout
information.
To Next Page
Loading...