363-206-305 Detailed Level Procedure:
DLP-500
Issue 3, June 2000 Page 5 of 8
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
11.
NOTE:
There are four types of users:
Privileged
users may execute any command, including restricted
commands.
General
users may execute any commands that are not restricted to
privileged users.
Maintenance
users may execute commands that obtain nonprivileged
system reports, perform protection switching, loopback activities, and
perform some other maintenance activities.
Reports-only
users may only execute commands that obtain
nonprivileged system reports.
Refer to
Security
in the "Administration and Provisioning" section of this
manual for more information about restricted commands.
NOTE:
Three privileged and up to one hundred nonprivileged (general and/or
reports-only) logins are supported. If a user attempts to enter another
login when the maximum supported logins already exist, the command
will be denied. See the "Commands and Reports" section of this manual
for a description of the set-lgn: command format.
Use the set-lgn: command to enter, edit, or delete nonprivileged (general
and/or reports-only) logins/passwords and user types, as required.
12. Use the rtrv-lgn: command to obtain the Login Provisioning
Report and verify the nonprivileged user logins and user types.
13. See the "Commands and Reports" section of this manual for descriptions of
related security commands: set-passwd, rtrv-lgn, and rtrv-secu.
14. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...