Lucent Technologies FiberReach DDM-2000 - Page 1492

DLP-500
: Detailed Level Procedure 363-206-305
Page 6 of 8 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
15.
NOTE:
You must be logged into the system as one of the three privileged users
to edit, delete, or enter a user's login. Initially, the defaults for the
privileged user logins are LUC01 (upper case LUC-zero-one), LUC02
(upper case LUC-zero-two), and LUC03 (upper case LUC-zero-three);
however, these defaults may have been changed.
At the login< prompt, enter a valid privileged user login (provided by your
DDM-2000 administrator).
Response: password<
16.
NOTE:
Check with the DDM-2000 administrator to determine what the default
privileged password is set to.
NOTE:
Passwords are not displayed on the CIT.
At the password< prompt, enter a valid password (provided by your
DDM-2000 administrator).
Response: CIT prints the following message followed by an Alarm
and Status Report:
TID date time
M rtrv-alm: all COMPLD
/* Active Alarms and Status Report
Lucent Technologies
DDM-2000 FiberReach
Release a.b.c
**********************************
**********************************/
/
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
*
.
.
.