DLP-509
: Detailed Level Procedure 363-206-305
Page 2 of 2 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
5.
NOTE:
When the
ACO/TEST
pushbutton is depressed, all LEDs and the
7-segment
FE ID
display on the
SYSCTL
light. If the
ACO/TEST
pushbutton is released within 2 seconds, the LED test completes and the
7-segment display and all LEDs revert to normal operation. If the
ACO/TEST
pushbutton is depressed longer than 2 seconds, the
7-segment display goes blank for 2 seconds and then each digit of the
generic software version code is scrolled through the display. The LEDs
remain lit while the code is being displayed. When the
ACO
pushbutton is
released, the LEDs remain lighted until the full software version code is
displayed. If the
ACO/TEST
pushbutton is still depressed when the
software version code has completed cycling, the display goes blank for 2
seconds and starts cycling through the software version code again. This
continues as long as the
ACO/TEST
pushbutton is depressed.
Depress the
ACO/TEST
pushbutton on the User Panel.
Response: All LEDs and the
SYSCTL
7-segment display light.
6. Was response correct?
If
YES
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE
.
If
NO
, continue with
Step 7
.
7. Were you sent here by another procedure to perform an LED test?
If
YES
, continue with
Step 8
.
If
NO
, do
Trouble Clearing: TAP-115
.
8. Record the circuit pack(s) (LEDs) that failed the LED test and return to the
procedure that sent you here.
9.
STOP. YOU HAVE COMPLETED THIS PROCEDURE
.
To Next Page
Loading...
Need help?
General
