Lucent Technologies FiberReach DDM-2000 - Page 1542

DLP-512
: Detailed Level Procedure 363-206-305
Page 8 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Cross-connection type twoway twoway
ent-crs-sts3c
Expected STS-1 path
trace message 62 characters see command pgs.
set-trace-sts1
Outgoing STS-1 path
trace message 62 characters see command pgs.
set-trace-sts1
Notes:
1. Default means factory default (the CIT prompts display current provisioned values).
2. To view the current values, precede these commands with
rtrv-
instead of
set-
† Parameter can be set for each port.
‡ AUTO means the port or channel is ready to be automatically provisioned via signal detection.
§ noOverride means read and use switch settings on circuit pack.
¶ Track means the source for timing will be selected from the active received OC-3 line specified.
** This command is available to privileged users only.
†† Rings.
‡‡ Setting this parameter also affects DS1 output source and DS1 sync output mode. See set-sync
command in Section 11, "Commands and Reports".
*** Parameters can be set for each channel.
††† Ring releases. Requires
26G-U/26G2-U/28G-U/28G2-U/29G-U/29H-U OLIU
s.
‡‡‡ Ring releases.
§§§ With
29G-U/29H-U OLIU
s in MAIN slots.
Table A – DDM-2000 FiberReach Parameters Provisionable Via the CIT (Contd)
Parameter Range
Default
(Note 1) Command (Note 2)