DLP-515
: Detailed Level Procedure 363-206-305
Page 2 of 4 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
2.
!
CAUTION:
The
init-pm:reg=all
command initializes (clears) all current day
and/or all current quarter-hour performance-monitoring storage registers.
NOTE:
If local procedures prohibit you from doing the init-pm:reg=all
command, you may perform the following in Steps 4 and 5. Use the
rtrv-pm-line command to obtain the line performance monitoring
status report, note the readings on the Today line in the report, wait
20 seconds, and then obtain another report. There should be no change
in readings from the first report.
Enter the command init-pm:reg=all, if allowed.
3. Wait 20 seconds.
4. Enter one of the following commands:
• rtrv-pm-line:main-1 if service OC-1, OC-3, or OC-12 line is being
tested.
• rtrv-pm-line:main-2 if protection OC-1, OC-3, or OC-12 line is
being tested.
• rtrv-pm-line:main-all if both OC-1, OC-3, or OC-12 lines are
being tested.
• rtrv-pm-line:fn-1 if service OC-3 line is being tested.
• rtrv-pm-line:fn-2 if protection OC-3 line is being tested.
• rtrv-pm-line:fn-all if both OC-3 lines are being tested.
Response: The following CIT report will indicate the status of the
equipment. The Today line should indicate that there are
no errors. Other Time lines may exist with numbers
greater than zero. (The "Commands and Reports" section
of this manual under
RTRV-PM-LINE
describes this
report.)
To Next Page
Loading...