363-206-305 Detailed Level Procedures:
Issue 3, June 2000 Page 1 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
DLP-525
Install Software Generic Program
Network Element Software
New Shelf Installation
Only BBG8/BBG8B SYSCTL Installed
1.
NOTE:
This procedure is used to install a software program in a new DDM-2000
FiberReach shelf equipped only with the BBG8/BBG8B SYSCTL circuit
pack. The circuit pack may be new from the factory or a circuit pack used
previously that may already be loaded with software. For procedures to
download software locally to a fully equipped in-service shelf, see
DLP-536. For procedures to download software remotely to a fully
equipped in-service shelf, see DLP-537.
NOTE:
It is assumed that the BBG8/BBG8B SYSCTL circuit pack has been
installed per DLP-539.
NOTE:
If you are using a PC operating in a
Windows
environment, you must exit
Windows
and restart your PC in MS-DOS mode before performing these
download procedures. For example, if your PC is running
Windows
95
you must exit
Windows
by clicking on the Start button, then Shut Down,
then Restart the computer in MS-DOS mode.
Obtain equipment, check software, and connect PC for download.
Reference: DLP-541.
To Next Page
Loading...