363-206-305 Detailed Level Procedures:
DLP-525
Issue 3, June 2000 Page 5 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
9. Was response correct?
If YES, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, continue with Step 10.
10. Did the download start as indicated by the In Progress message and rows
of dots?
If NO, continue with Step 11.
If YES, proceed to Step 18.
11. Check that the DDM-2000 is connected to the PC through the
COM
port. If it is
not, reconnect the PC to DDM-2000 using the
COM
port and repeat the
procedure.
If the download still does not start, as indicated by the In Progress
message and rows of dots, within 2 minutes after the P appears in the FE ID
display, change the CTRM baud rate as follows and repeat this procedure. If
the baud rate is currently set to 9600, change it to 4800 or if the baud rate is
currently set to 4800, change it to 9600. The baud rate is changed by:
1. Momentarily depress the "Alt C" keys.
2. Using the RETURN key to move to the "Speed" field.
3. Pressing the "Space" bar until the desired rate appears.
4. Momentarily depressing the "Escape/Esc" key to activate the new
baud rate.
12. Ensure first (number 1) disk of program being installed is inserted, if using
floppies.
13. Ensure diskette is inserted in correct drive.
14. Ensure the proper command was used to go to the drive with the diskette or to
the proper directory containing the software.
15. Check for invalid COM port. Exit TERM (Alt-F2); then restart TERM using term
COM1 or term COM2.
16. If the download still does not start, refer to Trouble Clearing: TAP-116.
17. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...