DLP-525
: Detailed Level Procedures 363-206-305
Page 4 of 6 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Letter "P." in FE ID Display:
6. Ensure PC is connected to the front CIT (CIT-1) connector of shelf receiving
software. If floppies are being used, ensure the first (number 1) diskette is
installed in floppy drive. If hard drive is being used, ensure you are in the
correct directory.
7. Enter
term
or
term COM
n
command, where
n
= 1 or 2. If term is entered
without the
COM
n
option, then
COM1
will be selected by default. If after
starting the terminal emulator you see the message "Can't find script
<init>", disregard it.
Two brief messages are printed and you are instructed to Press
any key to continue . . . after the second message. After
you press any key, the terminal emulator is loaded and the
terminal responds as follows:
CTRM ready. (Type Alt-h for help.)
Communications established.
8. Unplug and reseat the
SYSCTL
and immediately push and hold the
FE SEL
and
UPD/INIT
buttons at the same time until a
P
appears in the
FE ID
display
(approximately 15 seconds). Software download may take up to 45 minutes.
Response:
PC starts download and prints the following message:
Searching for optimal transfer rate. Handshake
established at <
baudrate
> baud.
In progress . . . .
The dots continue to print until program installation is complete. If
using the floppy disks, insert each diskette when prompted. After
installation is completed, the PC prints the following completion
message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The
SYSCTL
resets and the terminal is logged off the system.
After approximately three minutes, you can log into the system.
To Next Page
Loading...