363-206-305 Detailed Level Procedures:
DLP-525
Issue 3, June 2000 Page 3 of 6
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Letter "P" in FE ID Display:
3. Ensure PC is connected to the front CIT (CIT-1) connector of shelf receiving
software. If floppies are being used, ensure the first (number 1) diskette is
installed in floppy drive. If hard drive is being used, ensure you are in the
correct directory.
4.
NOTE:
After the terminal emulator (term) is started, the software download
automatically begins. The download may take up to 45 minutes.
Enter term or term COM
n
command, where
n
= 1 or 2. If term is
entered without the COM
n
option, then
COM1
will be selected by default.
Disregard message "Can't find script <init>" if you see it after
starting the terminal emulator.
Response: Two brief messages are printed and you are instructed to Press
any key to continue . . . after the second message. After you
press any key, the terminal emulator is loaded and the terminal
responds as follows within 2 minutes:
CTRM ready. (Type Alt-h for help.)
Communications established.
Searching for optimal transfer rate. Handshake
established at <baudrate> baud.
In progress . . . .
The dots continue to print until program installation is complete. If
using floppies, insert each diskette when prompted. After
installation is completed, the PC prints the following completion
message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the system.
5. Was response correct?
If YES, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If NO, proceed to Step 10.
To Next Page
Loading...