363-206-305 Detailed Level Procedure:
DLP-536
Issue 3, June 2000 Page 1 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Install New Software Generic Program
Network Element Software
In-Service System
Local Shelf Download
1. Before beginning the software installation, refer to the Software Installation
and Upgrade Procedure section of the Software Release Description. This
section contains a description of any special considerations required when
installing this version of software.
2.
NOTE:
This procedure is used to install a new software program in a local
in-service DDM-2000 FiberReach shelf. For procedures to download
software in a new shelf (initial installation), see DLP-525. For procedures
to download software to a remote shelf (using ins-prog: or
cpy-prog: command), see DLP-537.
NOTE:
If upgrading from earlier non-TARP software releases to TARP Release
3.0 and later, after the first shelf is upgraded, single ended operations will
not be available and major alarms (section DCC channel failed)
will exist until all shelves are upgraded. The node farthest away should
be upgraded first, working back to the local node.
NOTE:
If the ins-prog: command is used for software upgrades from TARP
Release 3.1, the software is loaded as a dormant copy in the SYSCTL
receiving the software. At the end of the download, the rtrv-alm:
report will show a status message of
dormant/exec code mismatch
.
The apply: command must be used to overwrite the original executing
copy of software with the new dormant software version. See the
Commands and Reports section in Volume 1 of this manual for a
description of the apply: command.
To Next Page
Loading...