363-206-305 Detailed Level Procedure:
DLP-536
Issue 3, June 2000 Page 5 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Letter "P" in FE ID Display:
5.
!
CAUTION:
If PC hard drive is being used, ensure you are in the correct directory. If
floppies are being used, ensure the first (number 1) diskette is installed in
floppy drive. Ensure PC is connected to the front CIT (CIT-1) connector.
NOTE:
After the terminal emulator (term) is started, the software download
automatically begins. The download may take 20 to 45 minutes.
Enter term or term COM
n
command, where
n
= 1 or 2. If term is entered
without the COM
n
option, then COM1 will be selected by default. Disregard
message Can’t find script <init> if you see it after starting the
terminal emulator.
Response: Two brief messages are printed and you are instructed to
Press any key to continue . . . after the
second message. After you press any key, the terminal
emulator is loaded and the terminal responds as follows
within 2 minutes:
CTRM ready. (Type Alt-h for help.)
Communications established.
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress . . . .
The dots continue to print until program installation is
complete. If using floppies, insert each diskette when
prompted. After installation is completed, the PC prints
the following completion message:
ins-prog:TID COMPLD
/* Generic a.b.c is installed */
The SYSCTL resets and the terminal is logged off the
system.
6. Was response correct?
If YES, continue with Step 7.
If NO, proceed to Step 26.
7. Did the letter "C" appear in the FE ID display?
If NO, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If YES, proceed to Step 22.
To Next Page
Loading...