DLP-536
: Detailed Level Procedure 363-206-305
Page 4 of 14 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
• Letter "F" in FE ID Display:
Indicates
SYSCTL
faceplate latch is not fully seated. If
SYSCTL
has just
been replaced, unplug
SYSCTL
and repeat procedures of
DLP-501
. If
original
SYSCTL
has just been unplugged and reseated, properly seat the
faceplate latch. (A reset occurs after the faceplate is seated.)
• Flashing Letter "L" in FE ID Display:
Indicates a low voltage condition (brownout) on the shelf.
Clear trouble using
Trouble Clearing: TAP-119
.
To Next Page
Loading...