Lucent Technologies FiberReach DDM-2000 - Page 1719

363-206-305 Detailed Level Procedure:
DLP-536
Issue 3, June 2000 Page 7 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
11. Enter the shelf number for the shelf being used for new program download.
Response: PC responds with:
12.
NOTE:
After the system prompt (<), the system will respond normally to
commands entered. The "Commands and Reports" section of Volume 1
of this manual gives a description of the commands.
Use rtrv-ne: command to retrieve the name (tid) of the shelf having new
program installed or see TID in response above. .
13. Enter the command ins-prog:tid .
Where tid = the target identifier (shelf name) for the DDM-2000
shelf having the new program installed.
Where pgmtype = the type of software you want to install.
Response: /*\ Testing For Program Installation...\ */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =
/*************************************
* *
* Lucent Technologies *
* DDM-2000 FiberReach *
* *
* Release a.b.c *
* *
*************************************/
.
.
.
TID date time
M rtrv-alm:all COMPLD
/* Active Alarms and Status Report