363-206-305 Detailed Level Procedure:
DLP-536
Issue 3, June 2000 Page 11 of 14
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Letter "C" in FE ID Display:
22.
!
CAUTION:
If the system is in service and is forced to run the current software that is
displaying a
"C"
, service interruption may result.
NOTE:
Indications are that there may be a problem with the version of software
you are installing or you are trying to install a version of software that will
not support the current shelf provisioning. If you are downloading an
older version of software or upgrading to a new version of software which
has major changes or is incompatible with the version that you have, this
indication will occur (See Table A). You can
force
the system to run the
current software or back out of this procedure by loading another version
of software.
You must decide if you want the system to run this current version of software
that has been loaded or if you want to download another version (original
version or new version) of software.
Do you want to run the current version of software in the SYSCTL?
If NO, continue with Step 23.
If YES, proceed to Step 24.
23. Exit TERM (Alt-F2). Find new version of software and repeat this procedure
from Step 18.
24. To
force
the system to run the current software, reset (unplug and reseat) the
SYSCTL to force it to run the current software.
25. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
26. Did the download start as indicated by the In progress message and rows
of dots?
If NO, continue with Step 27.
If YES, proceed to Step 29.
To Next Page
Loading...