DLP-537
: Detailed Level Procedure 363-206-305
Page 8 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
21. Enter the command ins-prog:tid.
Where tid = the target identifier (shelf name) for the far-end
DDM-2000 shelf having the new program installed.
Where pgmtype = the type of software you want to install.
Response: /* Testing For Program Installation... */
After several seconds, the PC prints a Caution!
message followed by the prompt:
Execute? y/n =
22. Was response correct?
If
YES
, continue with
Step 23
.
If
NO
, do
Trouble Clearing: TAP-116
.
23. Enter a
y
or
yes
and a carriage return to execute the program. Software
download may take up to 45 minutes.
Response:
ABN
LED lights on User Panel. A "
P.
" is displayed in
SYSCTL FE ID
display in the far-end shelf receiving the
program (for uncompressed executing copy download, not
if dormant copy is being loaded). PC starts download and
prints the following message:
Searching for optimal transfer rate.
Handshake established at <baudrate> baud.
In progress . . . .
The dots continue to print until program installation is
complete. If floppy disks are being used, insert each
diskette when prompted. After installation is completed,
the PC prints the following completion message:
ins-prog:
TID
COMPLD
/* Generic a.b.c is installed */
The
SYSCTL
resets, and the terminal is logged off the
system. The LEDs go off on the User Panel and
SYSCTL
.
To Next Page
Loading...