363-206-305 Detailed Level Procedure:
DLP-537
Issue 3, June 2000 Page 9 of 10
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
24. Was response correct?
If YES, proceed to Step 27.
If NO, continue with Step 25.
25. Wait approximately 5 minutes for the network to stabilize, exit term, then
repeat this procedure from Step 14. If the second attempt to download
software fails, do Trouble Clearing: TAP-116. You may have to go to the
remote site.
26. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
27. Wait approximately 5 minutes then verify communications can be
reestablished with far-end shelf using rtrv-map-network: command. Verify
that
Comm. Status
is good (not
FAILED
) as indicated by a blank in the
report.
28. Is communication status good between local and remote shelf?
If YES, proceed to Step 31.
If NO, continue with Step 29.
29. Dispatch technician to remote site and perform local software download
procedures.
Reference: DLP-532
30. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
31. Use rlgn:tid command to remotely login to far-end shelf.
Reference: DLP-522
32.
NOTE:
If a dormant copy was loaded into the far-end shelf and its release
version is different than the currently executing version, a status alarm
message of
dormant/exec code mismatch
will appear in the
rtrv-alm: report.
Use rtrv-alm: command at far-end shelf to check for alarm status message
of
dormant/exec code mismatch
.
33. Does alarm report indicate
dormant/exec code mismatch
?
If YES, continue with Step 34.
If NO, STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...