DLP-537
: Detailed Level Procedure 363-206-305
Page 10 of 10 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
34.
NOTE:
The software you downloaded has been loaded as a dormant copy in this
shelf. The original software is still the executing software. The apply:
command must be used at this shelf to install the dormant copy of
software as an executing copy. When the apply: command is executed
during an upgrade from Release 3.1 or later, if you do not specify a time
and date parameter, there is a default 15-minute delay before the
dormant copy installation begins. Once the installation begins, the
dormant copy is installed in approximately 10 minutes.
See the Commands and Reports section of Volume 1 of this manual for a
description of the apply: command. The apply: command allows you
to coordinate the software download across the network.
Are you going to use the apply: command at this time to load dormant
version of software?
If
YES
, continue with
Step 35
.
If
NO
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
35. Use the rlgn:tid command to login again to the remote shelf, then execute
the apply: command.
Response: At the local shelf, a "
P
" appears in the
FE ID
display when
the installation begins.
The
SYSCTL
resets after the software is installed.
LEDs and
FE ID
display go off on
SYSCTL
and User
Panel.
The remote login session is terminated.
After approximately 10 minutes, you can remote login
again to the remote shelf.
36. Was response correct?
If
YES
,
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
If
NO
, continue with
Step 37
.
37. Dispatch technician to remote site to perform trouble clearing procedures
and/or install software locally using the procedures of
DLP-536
.
38.
STOP. YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...