363-206-305 Detailed Level Procedure:
DLP-539
Issue 3, June 2000 Page 1 of 4
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
Install BBG8/BBG8B SYSCTL
New Shelf
1.
NOTE:
This procedure is used for installing the SYSCTL in a new shelf for the
first time (initial shelf turnup). For procedures to replace an in-service
SYSCTL, refer to DLP-501.
Set all SYSCTL switch S1 sections S1-1, S1-2, and S1-3 to OFF, to set the
product (shelf) type. See Figure 1.
2. Set SYSCTL switch S2 sections S2-1 and S2-2 to OFF and switch sections
S2-3, S2-4, S2-5, S2-6, S2-7, and S2-8 to ON.
Figure 1 – SYSCTL Option Settings
To Next Page
Loading...