Lucent Technologies FiberReach DDM-2000 - Page 1750

DLP-542
: Detailed Level Procedure 363-206-305
Page 2 of 4 Issue 3, June 2000
DDM-2000 F
IBER
R
EACH
W
IDEBAND
S
HELF
2. With both hands on the bottom of the Wall DT, carefully lift up on the Wall DT
so the pivot point leaves the service position, and slide the Wall DT forward
until the pivot point reaches the rotation position. Allow the pivot point to drop
down into the rotation position, and rotate the Wall DT 90 degrees until the
backplane is in the up position (see Figure 2).
Figure 2. Wall DT Cabinet — Bottom View
Attachment Screw
Attachment Screw
Mounting Screw
Mounting Screw
3/4 in Plywood typ.
Pivot point
Rotation position
Service position
tpa853933-01