Lucent Technologies FiberReach DDM-2000 User Manual

INIT-SYS 6of3Page INIT-SYS
releases,TARPlaterand3.0ReleaseFiberReachIn
theofpartbenotwillparameterGroupAlarmthe
set-ne willthereforeandparameters,provisioning
command.thisbyaffectedbenot
all addressThe all installationanofendtheatonlyusedis
allthatensuresThissystem.theoverturningbefore
valuesdefaultproperthehavesystemtheinparameters
done.isprovisioningsystem-specificanybefore
!
CAUTION:
addressThe all anonusedbeNOTshould
system.in-service
NOTE:
The init-sys:all toavailableiscommand
only.usersprivileged
underlistedparameterstheallinitializesparameterThis
sysctl following:thePLUS
Loopbacks
opr-lpbk-t1
Cross-connections
dlt-crs-vt1
ent-crs-vt1
thresholddegradesignalOC-1
set-oc1
set-sts1
set-vt1
thresholdsfailureSignal
set-t1
(SwitchingProtection manual)
switch-ls
switch-sync
OptionsFeature
set-feat
(TID)nameSystem
set-ne
PMN
set-attr-alm
laterand3.0ReleaseFiberReachIn—IdNEId,Site
willparametersIdNEandIdSitethereleases,TARP
byaffectednotarethereforeandavailable,benot
FiberReachDDM-2000 2000June3Issue 11-77

Lucent Technologies FiberReach DDM-2000 Specifications

General

Brand	Lucent Technologies
Model	FiberReach DDM-2000
Category	Multiplexer
Language	English