Lucent Technologies FiberReach DDM-2000 - Page 638

INIT-SYS 6of4Page INIT-SYS
command.this
set-ne
FiberReachIn—selectionCO/RTandTBOS
TBOSthereleases,TARPlaterand3.0Release
willitthereforeandavailable,benotwillparameter
command.thisbyaffectedbenot
set-ne
DCConsettingsUserSide/NetworkSide
LANIAOChannelDCC
set-fecom
ModeProtectionLow-Speed
matchtosetismodeprotectionlow-speedThe
Ifassembly.protectionlow-speedinstalledthe
detected,becanassemblyprotectionvalidno
1x7.todefaultsmodeprotectionlow-speedthe
addresstheenteringparameters,initializingtoadditionIn all will
failureForalarms.anddatamonitoringperformanceallclear
alarmstheinitialized,areparametersafterexiststillthatconditions
thisbyaffectednotareparametersdateandTimeredeclared.bewill
command.
anExecuting init-sys:sysctl setwillequippedpacksOLIUmainnowith
values:defaulttoparametersfollowingthe
OptionsFeature
3.0ReleaseFiberReachIn—(DSNE)ElementNetworkServicesDirectory
theofpartbenotwillparameterDSNEthereleases,TARPlaterand
set-ne thisbyaffectedbenotwillthereforeandparameters,provisioning
command.
(TID)nameSystem
PMN
thereleases,TARPlaterand3.0ReleaseFiberReachIn—IdNEId,Site
theofpartbenotwillparametersIdNEandIdSite set-ne provisioning
command.thisbyaffectedbenotwillthereforeandparameters,
thereleases,TARPlaterand3.0ReleaseFiberReachIn—AddressTBOS
theofpartbenotwillparameterAddressTBOS set-ne provisioning
command.thisbyaffectedbenotwillthereforeandparameters,
thereleases,TARPlaterand3.0ReleaseFiberReachIn—EnabledTBOS
theofpartbenotwillparameterEnabledTBOS set-ne provisioning
command.thisbyaffectedbenotwillthereforeandparameters,
11-78 2000June3Issue FiberReachDDM-2000