Lucent Technologies FiberReach DDM-2000 - Page 873

SET-SECU 6of1Page SET-SECU
NAME
SecuritySetset-secu:
FORMATINPUT
set-secu: Address [:[sec= Security ][,to= Timeout ]};
set-secu: Address [:[porttype= Porttype ][,baudrate= Baudrate ]
[,echo= echo ][,sec= Security ][,to= Timeout ]];
DESCRIPTION
CITeachonsecuritysystem(NE)elementnetworkconfigurescommandThis
willcommandthis4.0,ReleaseFiberReachwithStartinginterface.DCCand
CITfrontthefrommessagesTL1transmitand/orreceivetousertheallowalso
port.
areloginsdefaultthreeThe LUC01, LUC02 and, LUC03 upper-case(all
ispassworddefaultTheletters). DDM-2000 changeshouldusersPrivileged.
state.lockoutatosecuritysettingorsecurityenablingbeforedefaultsthese
NOTE:
only.usersprivilegedtoavailableiscommandThis
are:parametersinputThe
address noisThereports.DCCand/orCITtheofaddresstheisAddress
address.default
Addresses:Valid cit-1dcc-all,
porttype AddressprovisionedthewhetherSpecifies cit-1 -port(DCE
forusedisaccess)front CIT or TL1 ofvaluetheIfapplication.
isAddress cit-1 values:possibletwohavecanparameterthis,
cit or tl1 isvalueDefault. cit.
remoteTL150toupTL1,runtoprovisionedisportCITaIf
port.CITthatoncreatedbecanassociations
1:NOTE
thecommand,thisexecutingofresultaasIf porttype
from/tochangesvalueparameter’s cit to/from tl1 any,
terminatedbewillportspecifiedtheonsessionloginactive
andusersPrivilegedincludingoutloggeduser(s)theand
users.current
2:NOTE
Once cit-1 tosetisport tl1 reprovisionedbetoneedsit,
to cit again.usedbecanprogramCITthebefore
FiberReachDDM-2000 2000June3Issue 11-313