215651 106 Revision B
$
%
&
'
Figure 4.3: Hydraulic Hose Management System – All
Headers Except D115X
3. All draper headers except D115X: Push lever (A) up and
pull arm (B) to get pin (C) out of latch (D).
$
%
&
Figure 4.4: Hydraulic Hose Management System –
D115X Header
4. D115X Draper Headers: Pull hydraulic hose management
system (A) towards the left outboard end of the header,
disengage ball stud (B) from the cradle in support (C).
$
%
&
Figure 4.5: Windrower Left Outer Leg
5. Connect hydraulic hose management system (A) to the left
outer leg of the windrower by pushing ball stud (B) into ball
stud latch (C).
NOTE:
The hydraulic hoses have been removed from the
illustration for clarity.
HEADER ATTACHMENT/DETACHMENT
To Next Page
