MacDon D1X Series - Levelling the Header

215651 84 Revision B
3.12 Levelling the Header
The windrower linkages are factory-set to provide the proper level for the header and should not normally require
adjustment.
NOTE:
The float springs are NOT used to level the header.
If the header is not level, check the pressure of the windrower’s tires to ensure proper inflation (refer to your windrower
operator’s manual).
If the windrower’s tires are properly inflated and the header is still not level, adjust the windrower linkages as required
(refer to the appropriate section in the windrower operator’s manual).
OPERATION