215651 195 Revision B
Figure 5.154: Draper Connector
6. Wrap the draper over the drive roller and attach the ends
of the draper using tube connectors (B), screws (A),
and nuts.
NOTE:
The heads of the screws must face the center opening.
Figure 5.155: Draper Tensioner – Left Side Shown
7. Tension the draper. Locate adjuster bolt (A) and follow the
directions on decal (B), or refer to 5.7.3 Checking and
Adjusting Draper Tension, page 177 for proper draper
tensioning.
8. Disengage the reel and header safety props.
WARNING
Check to be sure all bystanders have cleared the area.
9. Start the engine and lower the header and reel.
10. Run the machine to verify the draper tracks correctly. If
additional adjustment is necessary, refer to 5.7.4 Adjusting
Draper Tracking, page 179.
5.7.8 Draper Deflectors
Narrow draper deflectors can reduce bunching at the ends of the header when decks are set for center delivery.
Removing Narrow Draper Deflectors
DANGER
To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and
remove the key before leaving the operator’s seat, and always engage the safety props before going under the
machine for any reason.
DANGER
Never start or move the machine until you are sure that all bystanders have cleared the area.
1. Raise the reel to its full height and lower the header to the ground.
2. If hydraulic deck shift is installed, shift the decks to create a work space at one end of the header.
3. Stop the engine, remove the key, and engage the reel safety props.
MAINTENANCE AND SERVICING
To Next Page
Loading...
