MacDon D1X Series - Installing Crop Divider Rods

215651 76 Revision B
Installing Crop Divider Rods
To install the crop divider rods onto the crop dividers, perform the installation procedure provided here.

$
Figure 3.50: Right Endsheet
1. Remove crop divider rods (A) from their storage location on
the inboard of the side endsheet.

$
%
Figure 3.51: Divider Rod on Crop Divider
2. Position crop divider rod (B) on the tip of the crop divider
as shown and tighten bolt (A).
3. Repeat procedure at opposite end of header.
OPERATION